Calibration Equipment

Product Details:

GILIBRATOR-2® Diagnostic Calibration System

Primary standard accuracy and performance validation for sampling pump air flows from 1 cc to 30 LPM

Other details:

• Low Flow Wet Cell -
• Dimensions: 2”W x 4”H x 2.1”D (51W x 102H x 53mmD) Weight: 0.4 lbs. (.18 kg)
• Standard Flow Wet Cell -
• Dimensions: 2.5"W x 6"H x 2.6"D (64W x 152H x 66mmD) Weight: 0.82 lbs. (0.37 kg)
• High Flow Wet Cell -
• Dimensions: 3.5"W x 8.1"H x 3.7"D (89W x 206H x 94mmD) Weight: 2.26 lbs. (1.02 kg)
• Flow Range,Accuracy -
• Low Flow Wet Cell, 1 - 250 cc/min., ±1% of reading accuracy; Standard Flow Wet Cell,
• 20cc to 6 LPM, ±1% of reading accuracy; High Flow Wet Cell, 2-30 LPM, ±1% of reading
• accuracy.
• Temperature Limits:
• Operating Temperature: 5 to 35C (41 to 95F);
• Storage Temperature: 0 to 50C (32 to 122F)
• Electrical:
• DC Power Source: Internal Battery Pack;
• AC Power Source: Continuous operation through adapter/charger;
• Battery Charge Time:14 Hrs.;
• Expected Battery Life: over 300 charge/recharge cycles;
• Transmission Link:RS-232;
• Interface Connectors: Charger Jack (2.1mm barrel jack), Printer Jack (DB-25), Sensor Jack - Wet Cell (DB-9)

Additional Information:

• Item Code: Gilibrator-2

Product Details:

Established in 1990, Instrumex is an ISO 9001:2015 registered company and one of the largest manufacturers and suppliers of Environmental Pollution Monitoring Instruments. Our strength lies not in just developing the instruments but providing a Total Solution for your pollution monitoring requirement. At INSTRUMEX, our passion is Continuous Research & Development of new technologies in Pollution Monitoring Instruments.

Product Specifications

Product Details:

A Noise Calibrator or Acoustic Calibrator is a hand-held device that emits an audible tone of very accurate level and frequency. Before making noise measurements the calibrator is fitted over the meter's microphone and the reading is either checked manually by the user or automatically by the meter.

Product Details:

The Soap Bubble Calibrators are meant for the calibration of air sampling pumps. These are in compliance with ISO 17025 standards and offers standard accuracy and performance validation while sampling pump air flows ranging from 1 cc to 30 LPM.

Temperature Limits

• Operating Temperature : 5 to 35C (41 to 95F)
• Storage Temperature : 0 to 50C (32 to 122F)

Electrical

• DC Power Source : Internal Battery Pack
• AC Power Source : Continuous operation through adapter/charger
• Battery Charge Time : 14 Hrs.
• Expected Battery Life : over 300 charge/recharge cycles
• Transmission Link : RS-232
• Interface Connectors : Charger Jack (2.1 mm barrel jack), Printer Jack (DB-25), Sensor Jack - Wet Cell (DB-9)

Technical Specifications